Applying Vinyl Siding Starter Strip

Locate the lowest possible corner that has sheathing.

Applying vinyl siding starter strip.

The bottom of the starter strip the part the bottom panel hooks on to should be at least. Find the lowest corner of the old siding or sheathing on the house. Slide it into the corner and nail it every 16 in. Snap each length of siding in place so that its bottom lip hooks under the starter strip.

Insert the flat hooked end of the zip tool under the lip on the bottom most edge of the vinyl siding panel that rests on top of the starter strip. Partly drive a nail 11 2 in. 13 simple vinyl siding installation tips use the wider starter strip. Measure a spot that is 1 1 2 inches above the bottom edge of the sheathing at this lowest point using a tape.

In order for the siding to be installed properly in a level fashion the starter strip at the bottom of the wall must be level. From that point measure up 1 4 6 4mm less than the width of the starter strip and partially drive a nail at one corner. This chalk line should be level and a consistent distance from the eaves or the top and bottom of the windows. Insulation for vinyl siding 1.

Vinyl siding starter strips. Mice bees and all sorts of other critters love making their home inside vinyl corner posts. This is where the new siding will begin. This video shows how to install a starter strip for vinyl and polymer siding installation.

Attach j channel trim strips around windows and doors and along the eaves. Staret strip secures the first course of siding to the home. Pull up as. Nail the starter strip to the siding aligning the top of the strip with the chalk line.

Pop a level chalk line for the starter strip an inch or two above the bottom of the siding. Cap the corner posts. Be sure to center the nails in their slots to. Position starter strip with the top edge of chalk line and allow room for corner posts.

How to install a vinyl siding starter strip step 1. Determine the lowest point of the wall that will be sided. Hold a tape measure against the exterior wall and travel. Nail vertical vinyl corners to the corners of the house making sure they are plumb.